General discussion

  • Creator
    Topic
  • #2313474

    Conecting to remote server on Wan whilst

    Locked

    by jonathan.gray ·

    Hello

    I’m have a serious problem, whilst dialled up to the internet, i cannot conect to remote servers on the wan, when connected to the internet the isp dns address is the default and i cannot ping
    anything on the wan.

    does anyone have anyideas im using a Win 2000 pro system.

    thanks

All Comments

  • Author
    Replies
    • #3394831

      Conecting to remote server on Wan whilst

      by quintar51 ·

      In reply to Conecting to remote server on Wan whilst

      Go into the dial up connection properties, Networking tab, TCP/IP, Advanced, DNS tab.

      Add your internal DNS server to this list, make it the first one, then add the ISP’s DNS server.

    • #3456343

      Conecting to remote server on Wan whilst

      by craig it mangaer ·

      In reply to Conecting to remote server on Wan whilst

      You have a couple of choices. First thing you need to do is make sure that your routing table is setup properly. You could even use the LMHOSTS file if necessary or a WINS server. If you have an internal DNS server you do want to make sure that is setup on your dialup connection. If you connect through the dialup at alternate locations you will need to make sure the ISP’s DNS information is also listed. You can also use the route add command to make sure that your PC knows about the other subnets on your WAN, if you do not have an internal DNS server. (make sure you make the route add persistent -P so that they are added automatically on reboot).

    • #3517952

      Conecting to remote server on Wan whilst

      by jonathan.gray ·

      In reply to Conecting to remote server on Wan whilst

      This question was auto closed due to inactivity

Viewing 2 reply threads