Question

Locked

Default Routing and Propagation of Default Routes On CISCO Routers

By cewcathar ·
Hi, I am a newbie studying for the CCNA,

with a question about the propagating of default routes when routing is enabled(RIPv2 OSPF, EIGRP, etc)
I have designed a network with different default routes I want to use, depending on the router (if it matters, for the switch, the default gateway is the ip of internal firewall router; for the internal firewall router the default route is the super-ip address for the proxy servers, which are configured as routers with ip forwarding; for these proxies, the default route is the ip of the external router)

Thus, I want to statically configure all default routes,
and I don't want any of these routes propagating to the rest of the routers--I understand that the default gateway configured on a switch--which does not do routing--will not propagate??

Think the default route configured on a router is not propagated by ospf even with routing on

In fact, I think only ip default-network command propagates a default gateway--otherwise, if you want default routes propagated, you have to do some more configuring.

Please advise. Is this correct???


--CEW

This conversation is currently closed to new comments.

0 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Share your knowledge
Back to Networks Forum
0 total posts (Page 1 of 1)  

Related Discussions

Related Forums