General discussion

Locked

Drop ICMP replies on pix 515

By chaosad ·
I have a pix firewall 515, I am new to cisco firewalls and am not very familiar with cisco command line setup at all.
How do i stop my firewall from relying to ICMP requests via the GUI?
I am also using a failover configuration.

This conversation is currently closed to new comments.

4 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by CG IT In reply to Drop ICMP replies on pix ...

which IOS?

IOS 11.x up

router(config)#access-list 101 deny icmp any host <device_IP> redirect
.... (the rest of the access-list 101)
router(config)#interface eth0
router(config-if)#ip access-group 101 in

Collapse -

by CG IT In reply to

I'll send you to this Cisco bulletin because different IOS versions require different fixes. you can obtain the PIX 515 firewalls reference command syntax from this Cisco link http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a008008d081.html

Collapse -

by chaosad In reply to

Poster rated this answer.

Collapse -

by chaosad In reply to Drop ICMP replies on pix ...

This question was closed by the author

Back to Security Forum
4 total posts (Page 1 of 1)  

Related Discussions

Related Forums