Discussion Locked

DSL and Network

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was not sure if I am to put this in the networking section or not, so I am putting a copy there as well....

I just got Verizon DSL on my XP Pro using my Ethernet card (sacrificing my home network). My other system is 98SE. What I need to know is what is the cheapest way to make both systems use the DSL for the Internet and still access each other?

Now, I have no available slots in my XP system, but I do in the 98SE. I have extra Ethernet cards too.

Can I, for example, hook up the additional card in the 98 system and hook up DSL that way and use Internet Sharing? Will both computers use the DSL at the same time (of course the host 98 has to be on) and still have both machines access each other? Is that possible?

Do I need a router, or hub, or both instead?
Please tell me what I can do and try. I know little on networks and, of course, am new to DSL (well, in my own home that is).
I am actually on a deadline of several days (free trial). I need my network and both machines to use DSL. My sacrifice I mentioned above can only be temporary.

Please assist.

17 replies

by parvus1202

There is router/modem with 4 port that you can use to connect to 1 or more computer. But of course the more computer connected the slower your browsing. Go to this site and get more info ...//http://www.comsal.co.uk/

by borginva

Sorry. I did not go this route (no pun).

I am awarding to the MOST used suggestions, and I am sorry I did not go with every answer. Also, I am not awarding to the same people on both this copy of the post and one in another board (as I stated inmy question).

by borginva

As a matter of fact, this is the exact one I bought from Circuit City. Got it for $60 wiith a $30 rebate. oth machines use the Internet with no lag I can find, and share files.
I was looking for something cheaper to buy, but CompUSA too pricey, 2 Best Buys, and 3 Circuit Cities later, this was the cheapest they all had stocked during the course of 1.5 weeks.

I am awarding to the MOST used suggestions, and I am sorry I did not go with every answer. Also, I am not awarding to the same peopleon both this copy of the post and one in another board (as I stated in my question).

by borginva

Sorry but the links did not work, but since you mentioned Netgear........ see above. I throw you some points.

I am awarding to the MOST used suggestions, and I am sorry I did not go with every answer. Also, I am not awarding to the same people on both this copy of the post and one in another board (as I stated in my question).

by timwalsh

Recommendations:

Hub/Switch: One of these devices will allow multiple computers to share a single Internet connection. I would go this route rather than multiple NICs. This will allow you to expand your network in the future.

Router/Firewall: There are many "Cable/DSL routers" on the market that also act as firewalls. I would highly recommend one for anybody that has a broadband Internet connection. Unless you are diligent about turning off your computer when you aren't using it, youhave an "always-on" Internet connection. This leaves your network wide open to all the ne'r-do-wells that skulk around the Internet. A firewall will prevent this.

Many ISPs also place a limit on the number of computers they will allow to connect from a given location. The Router/Firewalls on the market provide a capability called Network Address Translation (NAT). This protocol shows a single IP address to the outside world while allowing as many as 254 computers to be connected to an internal private network. These routers also function as DHCP servers to automatically provide your computers with private IP addresses.

Most vendors provide Router/Firewalls versions that have built-in hubs/switches, so you don't have multiple boxes taking up valuable real estate on your desk.

Hope this helps.

by borginva

I really needed to know a bit more on what to do, but thanks. I knew what they did but I needed to know what I actually needed. I had people telling me, for example, routers are not the answer, but a switch and hub (together) would. I needed to knowwhat I had to do to get it all working. Sorry.

I am awarding to the MOST used suggestions, and I am sorry I did not go with every answer. Also, I am not awarding to the same people on both this copy of the post and one in another board (as I stated in my question).

by borginva

I forgot to mention that when it comes to firewalls, I have software for it, and when the Internet is not being used, I disconnect the DSL.

by borginva

A reminder.... I not only need both computers to be able to access the Internet via the DSL, but to also access each other locally for sharing files and the printer.

by joerie_b

What ypu need is hub and two lancard installed in one of your PC running win98 or winxp..the LAN other card is connected to your internet connection or to your DSL and the other one is connected to your network or HUB..And use Wingate software to share your DSL Connection..install this software where you have two Lan card install..

by borginva

Sorry. Did not do this.

I am awarding to the MOST used suggestions, and I am sorry I did not go with every answer. Also, I am not awarding to the same people on both this copy of the post and one in another board (as I stated in my question).

by vze3bj9j

Check out the BEFSR41 DSL/Cable Router (Under $100).
It's a combination LAN/Router with a built in firewall.
Your DSL modem will hook into the Router as well as your PCs and allow both to share the modem and each other. Instead of internet sharing you'll now be able to use direct connect through a lan.
You only need to have an one ethernet card in each machine.
I using Win XP on one and was using Millenium on the other(now Win 2000)with no problems.
I have not noticed any decrease in speed when we are both brousing at the same time.

by borginva

Sorry. Did not do this.

I am awarding to the MOST used suggestions, and I am sorry I did not go with every answer. Also, I am not awarding to the same people on both this copy of the post and one in another board (as I stated in my question).

This discussion is closed to new replies.