Discussion Locked

Dual boot Win 98 and XP

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Is it possible to setup a computer to dual boot XP and 98 after XP has been installed?
I have 2 hard drives.
Thank you

11 replies

by Former member

Try the following explanation (not mine):

Drive C: must be FAT16 or FAT32 to be able to install Windows 98 after XP is already installed.
You must have a second hard disk or partition formatted for FAT16/32 in order to be able to install Windows98. I recommend the use of a Windows 98 Startup disk for this procedure.

1) Use a Win98 Startup disk to boot your computer.
2) Insert your Win98 CD into the CD-ROM drive.
3) At the A: prompt type D:\Win98\Setup.exe where D: is your CD-ROM drive.
4) Proceed with the install. When prompted for the install location, you'll see C:\Windows.000. Choose Other directory and change this to the drive you wish to install 98 to and name the folder Windows.
5) Complete the Win98 install. Allow the computer to boot into Win98.

Repairing the Windows XP Boot Loader

1) Create a Notepad file with the following entries, exactly as shown:

L 100 2 0 1
N C:\BOOTSECT.DOS
R BX
0
R CX
200
W
Q

3) Save the file to the Win98 Startup Disk as READ.SCR
4) Boot the computer with the Win98 Startup Disk and type

A:\DEBUG READ.SCR

5)Boot with a 98 Startup disk, and run WINNT.EXE
from the I386 folder of your XP CD.
6) Insert your XP CD and boot from it.
7) You'll see some files being copied, then you'll be presented with a choice of installing or
repairing an existing installation. Choose Repair.
8) You'll be asked which XP installation you want to log into. Enter 1. There is usually only
one installation.
9) You'll be prompted for the Administrator password. For Home, the default password is blank,
so just hit Enter. For Pro, enter the same password you did during setup for the Administrator account.
10) At the C:\Windows prompt, type FIXBOOT. You'll be prompted to confirm. Do so.
11) When FIXBOOT is finished, remove the XP CD and reboot.

You will now get the XP Boot loader with your choice of operating system

by cglrcng9

Or you could do what I did. I found it easier to use a shareware program that is reasonable in cost. Go to; http://www.simtel.net/pub/pd/58143.html Read up on BootItng.zip, I have no affiliation w/ the program makers. I tried the free trial period and liked it enough to buy it since it was reasonably priced. I wanted to install a dual boot to XP w/98SE installed, but it can go either way.

Good luck.

by c.barnhorst

Use Partition Magic or Partition Commander. Microsoft recommends that you install Win98 first and then XP. If you instal Win98 second it will not understand that there is another OS installed and think that the master boot record is corrupted and "fix" it. If you install WinXP second it will see that Win98 is installed and correctly set up the dual boot screen. The above two programs can solve this problem if you already have WinXP installed. Win98 does not seem to work well with more than512mb of memory so if your XP machine has more than that consider a separate machine for Win98.

by yonah

use your XP startup disks they have this in the advanced options + if you install XP over 98, xp will ask if you want to dual boot both os's.and auto partition the harddrive for you no other programs are needed; this feature i like about XP.

This discussion is closed to new replies.