General discussion

Locked

DVD player wont work

By leswilliams ·
Packard Bell pulsar 300 Ser no G958400319-Microsoft driver 4-23-1999-Samsung DVD_ ROM SD-606F.I only tried to play DVDs recently without success. CDs & CD-roms work fine.Zoran software. Despite re -inserting Dvd I always get the message"DVD drive empty or not ready" Tried different DVDs.Also tried with Real One playerand with PowerDVD

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by Oz_Media In reply to DVD player wont work

You MAY have a bad DVD, very common these days. The lasers are much more refined than CDROM requires due to the complex DVD layering.

Clean the drive, then have the hardware checked out.

Collapse -

by cvudayasankar In reply to DVD player wont work

Hello,
your DVD driver is not installed properly or the connections of data cable and powersupply cable is not in propermanner
you may configured the jumper settings improperly.
connect it in good manner then try it again.
Wishing you with regards
yours,
C.V.Udayasankar ,

Back to Hardware Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums