Question

Locked

Dymo 400 Printing issue

By LedMatrix ·
This is using the 2.5 x 1 labels (or so).

The printer will print one label then either push out a half a blank label or several blank labels. At that point the labewriter thinks it's out of paper. I also noticed that the labels tend to slide toward the middle while exiting. After each print I have to pull the labels back in and realign them. Then the process repeats.

This is a brand new labelwriter that I bought to replace the same brand writer that was having the same issue. So far I have reinstalled the software and replaced the USB cabel. Also noteworthy is that I used rubber rejuvenator on the rubber roller on the old one. That did not resolve the issue so I didn't try it on the new one.

Any help would be greatly appreciated.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Back to Peripheral Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums