Join or sign in Register for your free TechRepublic membership or if you are already a member, sign in using your preferred method below. Use Your Email Use FacebookUse Linkedin

efone services

Locked

whenever i start the ./eFoneSerial -i ttyS0..
It runs fine but in the messages..theres error..

GSM_get
_SMS: No OK was found in the output of the modem. Modem output > <. getTranjsaction: GSM_MDM_ERR_READ (STATE_LOGGED_ON_READ_ONE) it repeated few time then ./eFoneSerial: Let's get out of here. 🙂 Why?? but ppl can receive messages b4 the ./eFoneSerial stop.. Please help

Topic

Reply To: efone services

In reply to efone services

First try to find out if baud rates match…
Use minicom or kermit to try to access the modem
(if it HAYES compatible…) enter AT
It should respond with OK
If not it can be garbage (wrong baudrate)
or nothing.. (also wrong baudrate, or maybe the
modem was told to not echt and not shouw result
codes….) please consult your manual for the
exact commands needed to reset those..
Hayes: ATE1 or ATE0 should configure echo.

kind regards,
Nico

Reply To: efone services

In reply to Reply To: efone services

Because the interface is dropped when you stop
the driver the modem might execute all
outstanding commands. …

Reply To: efone services

In reply to Reply To: efone services

the baud rate is 9600
iam using Siemens M20 modem
Why the ./eFoneSerial stops by itself?

Reply To: efone services

In reply to efone services

Is there Nothing else in logfiles?
Then maybe have the loglevel set to debug messages
will show more. By default it seems to log only errors.. (LVL=LOG_DEBUG setting)

It stopps probably because the output from the SiemensM20 was not what it expected…
DEBUGGING info might show more.

Have you seen these manuals?
http://www.efone.com/doc/interfaces/efoneserial.html
http://www.efone.com/doc/howto/troubleshooting.html

Kind regards,

Reply To: efone services

In reply to Reply To: efone services

Poster rated this answer.

Reply To: efone services

In reply to efone services

This question was closed by the author

[Author]

Replies