Question Locked

emachine T2862 replaced the motherboard and power supply still no go

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying to fix an emachine T2862 that would not start. I replaced the power supply first since the old one tested bad and the fans and lights on the motherboard came on. but the hard drive would not spin. I swapped the ram with known good ram and still nothing. I checked the processor in another system and it works fine. I replaced the motherboard and it still does not work. I tried a different hard drive also and nothing. It will not even go to the POST any ideas???

2 replies

by rob miners

a new Motherboard or second hand. Is it identical to the one that it replaced.
If it is identical, here is something to try.

First thing to try is loosening the Screws that hold the Motherboard to the Case. They will only need a full turn. Reconnect the Power and turn it on. If it powers up shut it down and retighten the screws. They only need to be firm.

Carefully remove everything from the Motherboard. Remove the Motherboard and put it on an anti-static mat on a bench. Remove the Power Supply. Remove the Heatsink and give it a good clean. Remove the CPU and reseat it. Reinstall the Heatsink remembering to use CPU grease. Clean the golden edge of each memory stick with a soft rubber, remembering not to touch the golden edges. Check with one stick at a time, remembering to disconnect the power from the PC between checks. Connect a hard drive. If you have access to a PCI Video Card use it.

Reinsert the 20-24 pin power connector to the Motherboard. Connect a Keyboard and Mouse. Connect the Monitor. Connect the Power to the Power Supply. You can use a flat blade Screwdriver to short the Power pins on the Motherboard if you haven't got a spare switch. Turn it on and see what happens.

If it doesn't start at all its probably the Motherboard.

This discussion is closed to new replies.