General discussion

Locked

Error

By edellser ·
I have just installed 98SE on a K6II 500cpu, on a amptron board with 64MB ram with evrything on board. I keep on getting this fatal error "0028:C0005338 in VXD VMM(01) + 00004338. Current programm will close, press anykey to continue" Has any of youguys ever encounter this problem?

This conversation is currently closed to new comments.

6 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Error

by edellser In reply to Error

Point value changed by question poster.

Collapse -

Error

by maxwell edison In reply to Error

Greetings,

With Windows 98, there might be several causes.

A very likely cause is an incorrect setting in BIOS. Enter your computer's BIOS, go to the "PNP/PCI Configuration" section and change the "Plug and play Os installed" setting to "No".This cause/solution was seen on a Soltek Motherboard with an AMD 500MHz CPU running win98se. It could apply to others.

It is very likely that this is caused by overheating of the CPU. Check the CPU fan to make sure it is working, if it is you might try changing to a more powerful fan.

it might be related to incorrect CPU voltage settings on the motherboard

Another cause is mentioned at waynescomputerworld.com which suggests disabling the external cache if the problem happens during installation. Sounds like a good solution since there have been timing problems with AMD CPUs.

If all else fails try changing the CPU speed to a slower value and see if the problem goes away.

I'd try the first suggestion, reboot, and if it persists go to the second, and so on.

Good luck,

Maxwell

Collapse -

Error

by edellser In reply to Error

Poster rated this answer

Collapse -

Error

by zlitocook In reply to Error

Also check the on board video VXD probems are sometimes video related. Try a newer driver for it or disable it and try a pci video card to see it goes away.

Collapse -

Error

by edellser In reply to Error

Poster rated this answer

Collapse -

Error

by edellser In reply to Error

This question was closed by the author

Back to Windows Forum
6 total posts (Page 1 of 1)  

Related Discussions

Related Forums