General discussion

Locked

Exchange Server Restore Fail

By Jabulani ·
I am doing an Exchange Server restore using ARCServe but failing at the final hurdle.
I have successfully merged the database from the tapes to the new server.
When I start the restore of the Exchange Databases I get the following error message;
Restore Operation Failed
E8605 Failed to start restore DBNAME=\\Server\dbaexch EC=Backup agent Error - (331) *Insufficient privilege. Please check user privilege.

I am not sure what user privilege needs to be set to what

ArcServeIT System Account = zzBackup
Backup Agent RPC Server Service = zzBackup
User Account for restore Job = zzBackup

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Exchange Server Restore Fail

by William Shipway In reply to Exchange Server Restore F ...

The Microsoft knowledgebase has a few articles about problems with permissions when restoring Exchange - it is a common problem. You could also check the ARCserve support pages if not already done.

Check that the backup user has the correct Exchange administrative rights. You may also have to make it a local administrator on your Exchange server, depending on your setup.

Are you restoring it in a production environment or on a separate network? If on a separate network then make sure the domain is set up the same.

Sorry this is a bit generic but I haven't used ARCserve.

HTH
William

Collapse -

Exchange Server Restore Fail

by Jabulani In reply to Exchange Server Restore F ...

Poster rated this answer

Collapse -

Exchange Server Restore Fail

by Jabulani In reply to Exchange Server Restore F ...

This question was closed by the author

Back to Software Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums