Discussion Locked

Fatal Error Upgrading Win98 SE to XP

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am attempting to upgrade WIN98 SE to Win XP Proffesional. Very early on, during analising my PC, when the green bar has covered about 5% up pops "Fatal Error" - Setup cannot continue Error code 556FF58h. Contact Microsoft Technical.

Any Ideas.

5 replies

by thechas

Well, your error code as written does not show up in a search of Microsoft's web site.

I would begin by double checking that your hardware exceedes the minium requirements for XP, and that all devices and installed programs are supported in XP.
The compatability page is at;

http://www.microsoft.com/windowsxp/compatibility/default.asp

Remove any spaces from the pasted link.

Your next options, are to call or e-mail MS tech support.
Or, list your system specifications here in detail.

Finally, MANY users have had problems installing XP as an upgrade.
I recommend that you format your hard drive, and install XP onto a clean drive.
(back up your files if needed / possible)
You do not need to have W98 installed before installing XP, you just need to have the W98 CD on hand to prove you qualify for the upgrade.

Chas

by edsdave

If you have an AGP video cardin the computer that you are trying to upgrade the XP on try going into the bios and change the INITIAL DISPLAY setting to PCI SLOT without touching the video card. After the upgrade is completed go back to BIOS and change the initial display back to AGP and upgrade the video drivers.

This discussion is closed to new replies.