Discussion Locked

for the bin?

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have just aquired a 10gig H/D (seagate)i have been assured it was working fine (i have no way of knowing appart from word of mouth)i already have a 5gig installed so i set it to (slave)when i reboot into bios to auto detect H/D i get both pri master and pri slave (not installed)

I then shutdown removed both H/D and put in only the new one and set to pri master,done a reboot into bios and autodetect again(still didnt detect H/D)

anyone any idea as to what is going on,is it for the bin orcan it be another problem somewhere, can it even be that my pc cant run a 10 gig? (5400)

4 replies

by jereg

Here's what I would do. First, get another cable. Next, copy the drive info, heads,cylinders, and sectors. Go into the BIOS and pick the USER configuration, and enter the drive info. Connect the 10gb drive alone as primary, and reboot the PC. Oh, make sure that you have the pins and cable matching, pin 1 the pin 1. If they don't match, your drive won't be recognized.
Hope that helps.

by isys

If it's the only drive installed, make sure you have the jumper set for Master. If it's the slave, make sure your BIOS is set to Automatic so it will scan for the drive.

by kuhlio

One other thing that may be causing a problem is the jumper settings on the back of the 10GB drive. Check to make sure those are set properly (Master, Slave, Cable Select). IBM has a utility available for download that will check a disk for properfunctionality (despite manufacturer). You can get that at

Hope that can be of some help.

by bohicam1

Depending on how old your puter is, perhaps it cannot deal with a hard drive bigger than 7.8GB
Can you find out who the mobo manufacturer is? You can then see if there is a bios upgrade.
Good luck!

Mike

This discussion is closed to new replies.