Discussion Locked

FORMATTING

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
HOW CAN I FORMAT MY NEW SECONDARY HARD DRIVE ON WINDOWS XP?

11 replies

by mingteikg

Hi,

Is your new secondary hard disk recognized by WinXP? If it is recognized, please check the drive letter, and in Command Prompt (Start > Program > Accessories), type:

format [drive:]

You can also try going to Control Panel > Administrator Tools > Computer Management > Disk management and do the formatting there.

Hpoe this helps.

by dmiles

If the drive is being recognized in the Bios as the slave and your jumper settings are configured correctly

Double click on My Computer from Desktop,in the open panel,right-click on the second drive,in the drop down menu you you will see the option Format,click and then wizard to format drive will appear

by thechas

Before you can format a new hard drive, you need to partition the drive.

In XP, go to Administrative tools, computer management.
Under storage, click on disk management.
Right click on the new drive, select allocate / partition, and follow the prompts.

Chas

by sab_arturo

Try to set the jumper such that it is on "cable select" or remove all jumpers (should make it go to cable select) and try and reboot, windows should now recognize it. If not try it in a different computer is all I can suggest.

by design

Make a startup disk on A:
Load format.com on the startup disk.
Temporarily, disconnect your hard drive C: and make your 2nd drive (D:)a master.
(reset your bios).
Then start up from the startup disk.
fdisk the new(originally D:)drive and formatit.
Then make it a slave again and reconnect your original C: drive.
(reset your bios).

This discussion is closed to new replies.