Discussion Locked

Formatting a Win2k Drive?

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I learned in a class over a year ago that in order to format & reload Win98 onto a hard drive that has Win2K on it, a simple format c: /s wouldn't work. We had to run a program called "wipeout" (I think...) in order to make the drive fully reusablefor Win98. Does anyone know where I can find this program or an alternate solution for going back to Win98 on the same hard drive?

6 replies

by thechas

The simplest way, is to boot from the W98 startup disk and run fdisk at the DOS prompt.

Follow the prompts, and delete ALL partitions.

Then, re-boot from the startup disk, run fdisk again, and set up the partitions as desired.

Boot once more, and format at least the C: drive.
Then, with the W98 CD in the drive, run setup.

For more information, and links, check out
www.aumha.org (partitioning stratagy)
www.fdisk.com/fdisk
Links and information about fdisk

Chas

by thechas

Almost forgot, if Wipeout is what I think it is, it is a utility to overwrite the hard disk to make it difficult for anyone to recover the data from the drive.
Other than giving you a very clean drive, it likely will not change the drive from NTSF to FAT32 file system for W98.

Chas

by wcp

Using "Fdisk" to delete partition(s) works only if there's no logical drive with NTFS in an extended partition.

If this is the case, you need to boot with a Windows 2K CD as if you are installing Windows 2K. In the process, you get an option to delete the partitions, which you will delete.

Once the partitions are deleted, you quit the installation. Then you use a Win 98 startup disk to create a partiton and format the C: drive.

This discussion is closed to new replies.