General discussion

Locked

Full-duplexing / fiber and Transceivers

By c_coon ·
A student of mine has a problem with a network he is administering. He has fiber running between sites with Garrett transceivers (10/100)on both ends. The transceivers will not auto-negotiate (will not advertise full-duplex), and he has to switch tohalf-duplex for it to work. Any thoughts as to why the transceivers are being recalcitrant? He has talked to support at Garrett and their comment was "Well, it should be working."

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Full-duplexing / fiber and Transceivers

by Captain Krunch In reply to Full-duplexing / fiber an ...

Look for a defective end on a cable - had a similar problem SC connector turned out to be defective.

Collapse -

Full-duplexing / fiber and Transceivers

by c_coon In reply to Full-duplexing / fiber an ...

The question was auto-closed by TechRepublic

Collapse -

Full-duplexing / fiber and Transceivers

by gordito1 In reply to Full-duplexing / fiber an ...

take another fiber and try the transcievers to make sure they are good, the problem may be the fiber itself or the connector termination, retest the fiber.

Collapse -

Full-duplexing / fiber and Transceivers

by c_coon In reply to Full-duplexing / fiber an ...

The question was auto-closed by TechRepublic

Collapse -

Full-duplexing / fiber and Transceivers

by c_coon In reply to Full-duplexing / fiber an ...

This question was auto closed due to inactivity

Back to Hardware Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums