Question Locked

Hard disk capacity not tally with total partition space

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just bought a new pc without an OS and the CMOS showed that the hard disk has a total of 500GB memory. But when i try to setup microsoft xp, the total available partition space is only 131 GB. There are no other partitions created. Where did the remaining 369GB go?

8 replies

by oh smeg

XP SP1 or earlier could not support HDD's bigger than 127 GIG if memory serves me correctly. You can go into Drive Management and Format the unused part of the HDD there after you install SP2.

Of if you want to only have the 1 Partition you'll need to slipstream SP2 onto a Install Disc by either using this TR Article.

http://articles.techrepublic.com.com/5100-10878_11-6150784.html?tag=rbxccnbtr1

Download the PDF File

http://downloads.techrepublic.com.com/abstract.aspx?docid=172974

Or use something like nLite to make a Slipstreamed Install Disc

http://www.nliteos.com/download.html

Just a word or warning here though if you chose to use nLite you really need to read the Destructions available here

http://www.nliteos.com/guides.html

Col

by Former member

Please post back if you have any more problems or questions.

by qitian92

I have managed to get a newer xp cd with sp2 and i have since installed that. But the available partition space is around 470GB. Is this normal for a 500GB hard disk?

by rahouseholder

Hard drive manufacturers report the capacity of the drive in raw, unformatted space. I have a laptop with a 60GB drive and it only shows 55GB after formatting...

by oh smeg

As stated above HDD makers give a RAW Size without allowing for Formatting.

Also different Brands of HDD can format up to different sizes. A while ago when comparing IBM and WD Drives of both supposedly 80 GIG Capacity the IBM would always have a larger Storage area on it compared to the WD one after formatting.

470 Gigs is perfectly OK.

Col

by qitian92

Thanks to everyone who have helped!
You guys are really helpful!

A note to those who were suffering from the same problem as me:

Usually the new hardware now would require a windows xp cd with sp2 included in it as well to get optimum memory. Vista should be fine as well.

This discussion is closed to new replies.