Search

Hardware

General discussion

Gravatar
Locked

Have I killed my printer?

By david@haydenpub ·
Hello,
I have a Lexmark Z52 printer and have been refilling the cartridges. So far I have not had a problem but this time I got the cartridge too full and ink ran down the back over the contacts. I did not realize this until installed the cartridge and started getting blobs of ink on everything. Now, even with a brand new cartridge, the printer will not print color. Is there a way to un do this damage?

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
+ Follow this Discussion ·
| Thread display: Collapse - | Expand +

All Comments

gravatar
Collapse -

Have I killed my printer?

by dmiles In reply to Have I killed my printer?

It is worth a try to use alcohol and a q-tip and clean the printer heads and the internal parts of the printer,then use a old carthridge to try and clean the heads,if this an option using the printer setup.
Good Luck

gravatar
Collapse -

Have I killed my printer?

by david@haydenpub In reply to Have I killed my printer?

Turns out the printer was dead but this helped me figure that out.

gravatar
Collapse -

Have I killed my printer?

by estebandelatorre In reply to Have I killed my printer?

Probably not.
Plug it out from 110v
Use a q-tip with very hot water first to remove the ink, speccialy those places with too ink. For the most hard_to_remove surfaces, use some alcohol or better isoprophilic alcohol to remove ink.
Let the system 24hs and the plug it again.


Hope it helps

gravatar
Collapse -

Have I killed my printer?

by david@haydenpub In reply to Have I killed my printer?

Turns out the printer was dead but this helped me figure that out.

gravatar
Collapse -

Have I killed my printer?

by david@haydenpub In reply to Have I killed my printer?

This question was closed by the author

Back to Hardware Forum
5 total posts (Page 1 of 1)  

Start or search

Related Discussions

Related Forums