Networks

Question

Gravatar
Locked

How to increase bandwidth from 128kbps to 256kbps on NM-8S?

By dsebaster ·
I am new to this forum but been a member for a while and this is actually my first question. Thank you all in advance for any contributions.

I have an NM-8S module, it has 8 Low-speed serial(sync/async) interfaces on the 2811 ISR. All these ports are hard wired to 128kbps aggregate bandwidth. Is it possible to change the bandwidth on any one of these ports to another value in any way, maybe through some terminal configuration. One of these WAN interfaces is the Internet gateway to our ISP and we are supposed to be getting 256kbps through it. The question of buying another module is out.

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
+ Follow this Discussion ·
| Thread display: Collapse - | Expand +

All Answers

gravatar
Collapse -

What service is your carrier providing?

by robo_dev In reply to How to increase bandwidth ...

Is this a ISDN circuit, frame relay?

You have 8 serial WAN ports agggregated to 128kbps....are those dial-up lines?

gravatar
Collapse -

Cisco:

by seanferd In reply to How to increase bandwidth ...

<i>The 4-port (NM-4A/S) and 8-port (NM-8A/S) asynchronous/synchronous (async/sync) network modules provide async connectivity with speeds up to 115.2 kbps, and sync connectivity with speeds up to 128 kbps.</i>

http://www.cisco.com/en/US/products/hw/routers/ps274/products_tech_note0**86a00800a93f1.shtml

Back to Networks Forum
2 total posts (Page 1 of 1)  

Start or search

Related Discussions

Related Forums