HP 4200n false paper jam in tray 2 or 3, How can I "fake" out the sensors?

By ckelley114 ·
I replaced the fuser and did a full maintenance kit, I was getting the paper jam error 13.01.00 on all trays except for the manual tray, (tray 1).
I can print the menu map from tray 2 and it completes fine, but if I try to print the same job again, the paper never attempts to pick up the paper in tray two again. I can open the top and close it and it will resume printing. How can I "fake out" the paper sinsor? There is no paper jammed in this printer. I can even feed card through with no problem the first time.

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

Well obviously

by OH Smeg In reply to HP 4200n false paper jam ...

You need to reset the Sensors for the Paper Pickup.

If you have been using Heavy Card these get bent and need to either be replaced or readjusted. Look in the Service Manual for the way to do this.


Back to Peripheral Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums