Question

Locked

HP laserjet fuser

By palfer ·
from reading the tech articles it seems the fuser on my 3030 is what is causing the 1/2 inch line to be smudged on all my prints considering I've already tried replacing the toner cartridge. I'm not sure how to remove/replace the fuser or if it's even worth the task... Any suggestions?

This conversation is currently closed to new comments.

4 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

Maybe check here

by seanferd In reply to HP laserjet fuser

http://www.retrevo.com/support/HP-3030-Multifunction-Printers-manual/id/392ci660/t/2/

But a lot of those types of printers don't have easily available manuals, as the vendor wants to do the support.

Collapse -

parts and instructions can be found here

by computechdan In reply to HP laserjet fuser

http://www.printertechs.com/

i have used these guys a number of times and have always had a good experience.

kit for your printer w/refurbished fuser is listed for $119.00

Collapse -

Simple replacement

by mjd420nova In reply to HP laserjet fuser

The fuzer is usually held in place with two capture screws, one on each end and a power connector. Be careful not to disturb the serated edge foils. The replacement unit should also have a new cleaner bar. Extended life of the fuzer is insured if you replace the cleaner bar each time you install a new toner cartridge, it should be part of the toner kit.

Back to Peripheral Forum
4 total posts (Page 1 of 1)  

Related Discussions

Related Forums