Question Locked

HP Notebook recovery with failed LCD monitor

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a HP pavilion ZE5170 that got damaged in an auto accident. For a short time immediately after the accident, part of the LCD sreen was functional, allowing me to connect the unit to a monitor to check the condition of the system, although the LCD was degrading quickly as I worked. The only other apparent damage was to the floppy drive, which was destroyed, so I recently removed it from the unit, but the LCD screen is now totally dead, so I have no way of accessing the system, although I have transfered all of my data using a disk caddy. I'd like to use the beast as a small desktop equivalent by hooking it up to a monitor - a SAMSUNG SyncMaster 213T. However, the computer does not bring up the monitor automatically when it is turned on. Can anyone tell me how to bring up the external monitor upon startup? I am running Windows XP Pro w/SP2.

10 replies

by rob miners

Fn+F5 Toggles among the built-in display, an external display, and simultaneous display on
both.

by ajkamath

Good suggestion, but my monitor still doesn't show anything. Does the OS need to find a hard-wired notebook display to get past that point on bootup?

by rob miners

You wouldn't have a CRT Monitor to test on by any chance. Some brands have a Control Center to setup an external monitor independent to the OS.
Other than that I am out of ideas. :|

by rob miners

checked the manual and noticed that the notebook has S-Video support. It may run off your TV. ;)

< having a play >

by ajkamath

Thanks. I've a friend who has a couple of decent CRTs. I'll try them and give the S-video a shot this weekend.

by ajkamath

I tried S-video and two CRTs, but couldn't get any response. Another HP laptop (ze4900) immediately brought up the LCD and CRT monitors briefly upon startup, but then automatically switched back to the laptop screen. Toggling Fn+F5 worked just fine then. I have seen with some desktop systems that a monitor has to be attached to get past the initial boot sequence. It is possible that the BIOS on this computer has a similar quirk. That would be a pain, but it would also be so HP-like.

by rob miners

look for the onboard video first. I had the same problem with an acer the otherday but it would let me use a crt monitor.

Try pressing the lid switch just on the off chance that it sticks and thinks the lid is down so it turns off the display.

< from the manual >

External display does not work.
Check connections.
Press Fn+F5 several times.
Try display on another computer.

Likely Cause.
External display.
Motherboard

Doesn't look good.

by horus_k64

Can you please check what connectors the Samsung syncmaster uses, that should be the first question.

Second of all, from what I can gather, check your motherboard, what type it is, and it is advisable to read the documentation from the manufacturer.

Also, if none of the above offer a solution, check from your vendor, HP, what the Specs are and what type of BIOS does it utilize.

I hope this helped.

This discussion is closed to new replies.