Discussion Locked

I/O error

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I have a problem with my Win95 machine. When the machine boots up the following messages come up:

While Initializing device IOS:

Error: An I/O subsytem driver failed to load

Either a file in the ./iosubsys subdirectory is corrupted or the system is low on memory.

The system then give the options of booting the system is 1) Safe Mode 2) Ms Dos support and so forth.

I have tried to add some more memory but it doesn't solve the problem.

Please advise.

Regards,
Edmond

7 replies

by thechas

First, you can have too much memory in Windows 9X.
If you have over 511MB of RAM, that may be your problem.
There is a Windows bug that can cause system problems with over 511MB of RAM.

Second, 1 or more of your memory modules may be bad, or incompatable with each other.

The bad news is that if you have booted several times with a memory problem, you may have damaged the iosubsys and \system32 files.

You may need to boot from a floppy, and navigate the hard drive from DOS.
go to both the c:\windows\iosubsys and c:\windows\system32\ folders, and rename any suspect files to *.bak
Under system32, the files in question will all have .vxd as their extension.

Attempt to re-boot into Windows.
If you suceed, you will need to re-install some device drivers.

If you cannot boot into Windows, select files one at a time to rename back to their old extensions.

Chas

by gary mcp

I've seen this one before, it's a known issue with win95. Have a look at MS KnowledgeBase article 225497.

This problem can be worked around by adjusting the maximum cache size allocated by Vcache.vxd. Vcache.vxd allocates an initial cache size that is no larger than 9MB. Setting the maximum cache size to less than 9MB also reduces the initial cache size, freeing up memory below 16MB and allowing Windows 95 to boot properly.

The maximum cache size is set by adding a "maxfilecache" line to the vcache section of System.ini. The following example shows what an entry in System.ini would look like to set the maximum cache size to 6MB:

[vcache]
maxfilecache=6144

Hope this helps!
Gary

by aramos15

I think your problem is a device with a driver bad.
When you turn on the pc and the message Windows 95 booting you must press the F8 key to interrupt the normal boot and when menu is displayed you can use the safe mode typical number 3.
if you canboot in the safe mode then you can use
start
settings
control panel
net
first uninstall the ethercard if you have one.
and then you can down the computer and turn off and on again and left run normal. If you can boot is the ethercard driver if dont try with the AOL driver tipical failure, uninstall and down again your pc. is a tedious process.
good luck.

This discussion is closed to new replies.