General discussion


IBM 300GL model 6282-69U

By alex_o_99 ·
My pc will not boot up after reinstalling Win95. it will have a blinking cursor on the top-left of the screen and a number 67 to the top-right side of the monitor. It will not allow me to go to the BIOS config. nor it will boot up with a floppy or CD. please Help!!!!

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by willcomp In reply to IBM 300GL model 6282-69U

For IBM PS/2 models, error code 67 reported a hard disk configuration error.

Try disconnecting hard disk and see if PC boots. If it does, reconnect hard disk, ensure that cables are seated properly, and reboot.


Collapse -

by alex_o_99 In reply to

Poster rated this answer.

Collapse -

by 1 Sane Nerd@Work In reply to IBM 300GL model 6282-69U

remove the hdd from the system. boot up w/o hdd. Clear the cmos and set new ones, saved it. is the win95 fresh install i.e. not a ghost image? have u set partition active for the boot partition c: (set active). is the hdd capacity too high for the bios to detect? some of this bios has a 20GB limit.

Back to Windows Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums