General discussion

Locked

ibm 6.0 thinkpad

By melvin19 ·
error: 0175 bad cr1 stop post task
it's been stated that PC ERROR REPAIR will work

NOTE:
when i turn on my laptop,it will boot no further than the error message. how can i get
error pc repair to install in my laptop.when all stops at error message.

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

If the PC won't pass POST (power on self test)

by robo_dev In reply to ibm 6.0 thinkpad

then most likely either the system board has failed, the bios has been corrupted, or you have a bad memory chip or two.

Unplug all components, including memory and all cards, drives, batteries, and try getting it to boot.

Some PCs use a jumper to reset the bios to factory defaults, and in some cases if you disconnect the CMOS battery, the bios will be reset.

If your bios is corrupted, then the choices are to replace the system board or try one of the services who can re-flash laptop bios:

http://www.badflash.com/

Back to Desktop Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums