Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have NT installed on an Intel L440GX+ MotherBoard w/ onboard SCSI & IDE. There were no IDE devices present upon installation. I beleive that IDE drivers were never installed because after hooking up an IDE drive to the board Disk Admin would not detect the drives. The customer now has purchased an ATAPI Travan drive which aslo will not detect. I have come to the conclusion that since the installation was done on SCSI drives NT did not load any IDE controller device drivers. How can I get NT to install IDE controller drivers? Do I have to reinstall NT with at least one IDE hard disk in place? Is there an easier way?
5 replies
by tprinzo
You should be able to do it through Control Pannel SCSI Adapters, Drivers tab and add the drive. The system then should be able to see the IDE hardware.
by the-iceman
Poster rated this answer
by rlevesque
Which version of NT?
in NT4, first enable the IDE connection in the motherboard CMOS. Then within NT, go to Control panel, SCSI Adapters, and add the IDE device driver there. Should be under the top item, standard mass storage device.
in 2000,it should auto-detect upon restarting after enabling the IDE controller in the board's CMOS.(or that is atleast the claim right?).
by the-iceman
Poster rated this answer
by the-iceman
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
16 replies
0 helpful
13 replies
0 helpful
3 replies
0 helpful
2 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply