Question Locked

I'm running Vista and Myspace "crashes" my Netgear WGT624 v3

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently bought a Dell Inspiron 1501. I upgraded the memory to 2GB and reinstalled everything. The laptop runs Vista Home Basic and has a Sempron 3500+ 1.8GHz. My Router is A Netgear WGT624 v3.

I have seen various forums out there discussing why Myspace "crashes" their router. I too have had the problem. Some forums discuss MTU settings and others have suggested unchecking IPv6.

I have a desktop that I connect with cat5 and have never had this issue. It's a P4 3.0 with 1GB.

I began to look at settings from the bottom up; namely the device settings. I adjusted the fragmentation threshold from 2346 to 2306. Granted I am no pro at tweaking device settings, I understood that this setting will hep me control the size of packets; more or less.

It helped a lot. Pages load 80%+ error free now. I am seeking to understand why this seems to reslve this issue, maybe just for me, with much more efficacy than I have read about.

All your thoughts are much appreciated....

3 replies

by seanferd

before they are broken into smaller chunks. "More easily digestible" would be a metaphor, if that helps.

You didn't lower the setting too much, but since it helped, I would suggest lowering it a bit more to get near 100% error-free page loads. Drop it another 40 or so.

Note: Vista is *supposed* to tune TCP settings itself, so I wouldn't randomly cavort about the Windows settings. You can run a "tweak test" here:
http://www.dslreports.com/tweaks
and perhaps adjust some router settings as well. They will give you warnings about Vista, too. There are also explanatory pages on the subject.

Check around the rest of that site, you may discover some other interesting things.

by l-mo

So, I spent some time reading and searching the site. Thanks!!! I came across the notion of tweaking my RWIN setting after reviewing a tweak test.

http://www.dslreports.com/tweaks

After disabling my firewall software, router and the likes... I found that in theory increasing my RWIN from the default 17520 to 35040 has made a difference.

I ran the tweak report again and saw a doubling in retransmits; from 2 to 4. For what this machine does that's more than ok.

I then reapplied my firewall and router settings and rebooted the laptop.

Browsing Myspace and other sites went smoother. What was more noticeable was the CPU and memory usage. Where previously some sites peaked the processor and used little memory, I know see more even CPU usage and an similar increase in RAM use.

Is this resulting from my CPU processing data more efficiently? These types of sites pull data from multiple locations, does this play into the scenario?

Any insight would be great. Thanks :)

This discussion is closed to new replies.