General discussion

Locked

install Win2k over linspire4.5

By kmedd3 ·
new machine has linspire4.5, attempt to install win2k over. During boot, noticed error "IDE channel 1 80 pin conductor not installed. during setup, received error codes -i/o 3200- multiple times. Final result:win2k would not install. As new out of box machines (4) I assumed there would be proper cabling, tried to uninstall linspire4.5 and had some results.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by wcp In reply to install Win2k over linspi ...

The first error indicates that the IDE cable is 40 not 80 conductor cable. The 40 conductor cable will limit the HD data transfer rate to 33MB/sec.

Linspire does not support dual boot with Windows. However, if you want dual boot, either you install Windows first then Linspire or you have to reinstall Linspire after the Windows installation. They must be in separate partition or drive!

Refer to
http://tinyurl.com/772ca Can I to dual boot between Linspire and MS Windows? If so, how do I do it?

http://tinyurl.com/c7zna How do I uninstall Linspire 4.5/5.0 and remove the Linspire 4.5/5.0 boot screen?

Collapse -

by kmedd3 In reply to

This answer was right on the money with my research. thank you for your input and accuracy.

Collapse -

by kmedd3 In reply to install Win2k over linspi ...

This question was closed by the author

Back to Windows Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums