General discussion

Locked

Installation of SCSI controller in NT4.0

By busygcg ·
I'm trying to install NT40 server on a Compaq ap550 with an Ultra3 SCSI controller. It recognizes the controller initailly then says there are no drives connected to the PC. Does anyone have a solution to get NT4.0 server to install the controller to recognize the drives?

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Installation of SCSI controller in NT4.0

by jgraham In reply to Installation of SCSI cont ...

If this is on inital setup of NT 4.0 then when the Blue Screen starts press F6. This will bypass the loading of other SCSI drivers. i.e. Adaptec which will interfear with the ap550 SCSI driver.
Once the drivers are loaded then proceed. The OS should recoginize the drives after that.

Back to Windows Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums