Discussion Locked

Internet sharing with static IP's

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I get internet conection via one Network card on my computer. I want to extend my connection to my LAN. I have win2k server installed. I also installed a second network card that carries IP : 172.16.10.1 and all my other PC's cary 172.16.10.X. I want to share this connection without using a proxy lin wingate or...
Does it involve DNS configurations ? I hear it has something to do with RAS and routing.
Please advise me.
thanks
Julius

13 replies

by dave.osborne

You could make things a lot easier and just go with a router in your setup. Hook the incoming IC to the router, and then the router to the NICs in your computers. Quite easy to setup and most of the work is done for you with a few inputs into the router config. Email if you would like more specifics.

-Dave

by cg it

Essentially your server is or will be acting as a gateway if your using two NICs. An external NIC for WAN and the second for LAN. The default gateway out would be the external nic [provided your not using a router in between your ISP modem and your server. Clients would connect to a switch or hub with an uplink to the internal [LAN]NIC, [and as mentioned above, TCP/IP properties would be configure to have the server external NIC as the gateway IP address [or if you do use a router, the router IP address]. IE or whatever browser you use is configured to auto detect. Routing and Remote Access [RRAS] is primarily for dial up and VPN inbound/outbound connections.

by cg it

note: TCP/IP properties bound to NIC's on each client computer would have their static IP address and submask #'s assigned by you with the gateway IP address as the servers external NIC IP address. Note: this configuration requires the server to "always be on" for client computers to access the internet.

by cg it

another note: you do not have to have DNS running unless you have a FQDN you wish to have advertised publically and/or have a public web or FTP site accessible from the internet.

by cg it

ICS is a Wizard that automates the process of setting up the TCP/IP properties for a range of Internet Connections [such as VPN, Dial up, Proxy server etc. You don't have to use it if you manually configure your settings. In fact, setting up your TCP/IP addressing scheme manually and then running ICS will most likely cause errors as the wizard will reconfigure the server settings that you've already configured.

by cg it

joerie also is correct in using NAT [network address translation] for internet connection for client computers. NAT is a more secure method for private LAN's to provide Internet access to clients. Private client IP addresses are not shown publicallythough the internet.

by homer simpson

Answer 2 is correct. but what i can not solve is that when you configures ICS, an error occurs saying that it will use xxx.xxx.xxx.1 for the gateway. I have a router configured at xxx.xxx.xxx.3 and no computer on xxx.xxx.xxx.1 but it keeps tellingme that there is? Any ideas?

by joerie_b

You can use your win2k server us your gateway or proxy. Open administrative tools open Routing and remote access, and configure and routing and remote access, click Next, chose internet connection server, and chose NAT routing protocol and then chose the NIC that you have a internet connection and then click NEXT and finish.

This discussion is closed to new replies.