Discussion Locked

invalid media type

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed a new hard drive and everytime I reboot it tells me Invalid media type. How do I correct this? Please help quickly! I'm getting frustrated.

11 replies

by ann777

Use a boot disk and run fdisk and partition the drive. Then reboot to the floppy disk again and when you get to the DOS prompt, type "format c:/s" (without the quotation marks) and format the drive. After formatting the drive (with the /s parameter -- which adds the syatem bootable files to the drive), you should be able to remove the floppy and boot directly to the drive. Then copy your Windows cab files to a subdirectory on the drive and run setup from the hdd.

by joe

Did the hard drive came with a setup floppy? If not you can go to the maker of the hard drive and download a setup disk.

by guyp

I must agree with Anna777, just seems to me that your drive needs to be re-partitioned and formatted. One thing I would like to add, depending on how old your system is and the size of your new drive, older systems have a hard time recognizing drives over 30GB, if you have an older system you may want to try upgrading your BIOS if Anna777's suggestion doesn't work.

by rcom

This can be caused by one of three following reasons:

The hard disk drive does not have a valid format.
The hard disk drive has been fdisked but not formatted.
The hard disk drive is bad.

Solution:

The hard disk drive does not have a valid format.

If you formatted the drive without the SYS command that's the problem. tYpe the following command.

Sys c:

Once you have received the message System Transferred reboot the computer and your issue should be resolved.

If you receive the same Invalid Media Type reading type reading drive C: there's no format on the hard disk drive or it's is invalid. Re-format the hard disk drive. By typing the following after booting from a bootable floppy diskette:

Format c: /s

by madhusoft

clompetely format the Hard disk

boot with a floppy
and use fdisk remove all partition
and repartition the HDD
the format all partitions and
install the OS
it will work fine
if not means its a hardware fault

This discussion is closed to new replies.