Discussion Locked

ISA FirewallClient and Group Policy

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have setup an ISA 2000 Server for firewall. It works except this one problem. When I setup a system on the network and the ISA server I have to give the user admin rights on system, install ISA client, then remove admin rights. If I do not do this for each user on the system, what ever user I do not do this for can not access the internet. Yes, I have put all users in the "Internet users" group for internet access. What I would like to do is put the ISA firewall client setup into a grouppolicy and assign it to all users. It works except for one thing, the user has to have admin rights on the local system or the client setup hangs. My question is 1. is there an easier way to do this and 2. if I am going about it right, what do I have to do so that the group policy with run the client setup as and admin?
TIA,
David

3 replies

by cg it

to answer, Active Directory works with ISA server in allow or deny particular groups internet access. This is done by ISA packet filters in both access policy general rules, ("access site and content rule properties", "applies to" tab, "users and groups") and the IP packet filters portion of access policy of ISA server. Also note: upon installation of ISA server, DHCP client packet filter is by default, disabled and must be enabled before clients can access the internet through ISA server. Alsoif your using ISA as a firewall, network client configuration must be configured to allow firewall client access to the external connector either via DNS name and IP address or Automatic discovery in firewall client. You can also define client address sets in the access site and content rule properties, "applies to" tab. As long as you specify a particular "group" as having access, and those you wish to have access are assigned to that group via Active Directory, once AD updates the security record, those in that groups will have access without having to grant admin rights for a short time.

by david__

Thanks for the answer, but those things you answered with do not answer my main question. The main question is "how do I configure the ISA Firewall client to run with admin rights through group policy?" The reason for the question is, "for every user that logs into each system, for some reason, must have ISA Firewall client installed for that user, and the client does not seem to perform a successful install unless the user is a local admin of system.
Thanks again,
David

This discussion is closed to new replies.