Question Locked

LAN SET UP WITH PUBLIC IP

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Lets Suppose, I have a simple internet with router dlink DIR-615 Or TPlink i dont know how to disable nat at first,I have got some of the IPs from the ISP side, which I am trying to use with my all 5 computers to remote access, which are as follows.....
65.45.12.16
wan port Ip 65.45.12.17
65.45.12.18
65.45.12.19
65.45.12.20
65.45.12.21
wan port Gateway IP: 65.45.12.22
65.45.12.23
if i put this ip inside lan it will work even i cant disable nat in my routers or what i can do
plz help for CONFIGURATION....Thnx

3 replies

by seanferd

As you have directly assigned public IPs to each computer behind the router.

by cg it

while I'm not familiar with that dlink model[or dlink for that matter], many consumer level routers have 2 modes gateway and router.

Gateway mode provides NAT and firewall services.

router mode does not provide NAT or firewall services.

But why even have a router. If you have been assigned a block of addresses on your connection, simply use a switch.

you are directly connected to your ISP network using public routable addresses so you really don't need a router.

Consumer level routers simply provide NAT services so that many computers can share a single connection [and single public address].

This discussion is closed to new replies.