Question Locked

lap top could not read/connect to MP4

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Good evening every body,

I have an MP4 of Sonny 689 with the memory of 256. Recently I have tried to connect it with my laptop but on the screen of the MP4, there was no symbol of connections as there used to be. In "My computer" window, no removable driver icon was shown. I have tried two other hubs or whatsoever where we connect the USB with the computer, I failed too.
Before, I had a problem with the flash driver when connecting with the laptop too. It warned that (I don't remember exactly the words) the hub could not read the driver since it was overwhelmed with energy. I did not read the instruction very carefully, just closed the window, and tried again and again until it worked. However, later I realized that the action of just closing the warning window was not risk-free. It seems that such action implied an agreement that the hub would not work any more or so.
Now I wonder whether there is a link between my actions in the past and the current problem? And most importantly, what should I do to solve them - the current problem with my MP4 and the past one with my flash driver.
Thank you very much in advance!

Dinh Huong,

3 replies

by Former member

Connect it directly to your computer. On your laptop connect it directly to the usb port if you are using a pc then connect it to the back usb port. Make sure that your motherboard drivers are loaded to each computer for this to take affect.

Please post back if you have any more problems or questions.

by oh smeg

Boot your Computer plug in the USB Device directly to your M'Board and then open the Drive Manager.

Locate the Device there right click on it and chose Change Drive Letter. Change the drive letter to something not in use and see if it now works.

The problem with Unpowered Hubs is that NB's don't have a lot of power available so when you start plugging in several USB Devices which draw power from the NB the power goes low to such an extent that the devices may not have enough power to work correctly.

Col

This discussion is closed to new replies.