Question

Locked

LCD Goes Blank

By rhingraham ·
My Inspiron 6000 LCD goes blank typically a few minutes after boot up. Plugged into external monitor works fine. I have replaced the Inverter board and the LCD - no difference. Many times it will work fine on power for an hour or so, but the minute I unplug from power - goes blank (and by blank I mean a faint image on the screen). When I jiggle the power cord in and out it will often come back for a few minutes - but anytime the power cord is pulled out - immediately blank. Bettery is fully charged and fairly new.. Bad cable of some sort? Anyone have any ideas? Much appreciated...
Rich

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
Thread display: Collapse - | Expand +

All Answers

Collapse -

First thing to check...

by CaptBilly1Eye In reply to LCD Goes Blank

just to be sure it's not a setting issue...

1. Right click on an empty spot on your Desktop and select Properties.
2. In the Display Properties window that opens, click on the Screensaver tab.
3. Click the Power button.
4. Under 'Running on batteries', make sure the monitor is not set to quickly turn off.

Other than that, It could be a backlight issue, but I tend to doubt it. It would likely be best to have it tested at a service facility.

Collapse -

Bet the back light is going out.

by archie.kubacki In reply to First thing to check...

it is easily replaced.

Collapse -

hardware

by jgirizarry In reply to LCD Goes Blank

Sounds like a hardware issue, if you still have a warranty, call Dell and make arrangements.

Back to Windows Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums