Question Locked

Making a Y/C Male to BNC Male Splice

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hello to all and anyone that has the knowledge to share. I'm trying to make my own cable converson when compared to what it will cost to purchase and feel that it should be quite simple to make a 2-conductor cable. But before I go buying brand new cables and chopping anymore of them up I wanted to grasp a better understanding. I made a successful splice but when I went to view my video output all I got was pretty black & white image. From the BNC cable it's just a Tip and a ground. From the Y/C cable I had used the Chrominance and the Chrominance ground. Should I have used the Luminance and the Luminance ground to get a color output? If not what then? I'd like to acheive a color output for an upcoming project I have. Thanks in advance...

3 replies

by thechas

Here is a link to an adapter cable diagram.

http://www.hardwarebook.info/S-Video_to_Composite

The center of a BNC cable is the same as the center of a RCA connector.

I would make the connections as close to the S-Video connector as possible and run coax to the BNC connector.

That said, I usually can find most cables for less than I can build them.

Sources like Digi-Key, Cables to Go and L-Com all have a variety of cables at good prices. Plus, you get molded ends.

Don't neglect surplus sites like All Electronics, BG Micro and Hosfelt Electronics.

Chas

This discussion is closed to new replies.