Discussion Locked

memory parity error when acessing modem

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I work for a company who refurbishes second user equipment and have recently come across a problem that has me baffled.
It involves a compaq 5100 professional workstaion running on a P11 350,128MBs of ram,4.1GB SCSI HDD, LS120 super disk drive, 32 speed cd-rom and win95.
I installed a intel Ham v90 data fax modem and the install procedure went smoothly but when the modem is acessed it causes a blue screen with the simple message Memory parity error and the computer then has to be powered of to restart it, my initial thaught was to test the modem on one of my test beds witch i did and it worked fine discounting the modem as being at fault. So i then ran pc check on the compaqs ram using a full test and this also tested up ok so i don't understand where the memory parity error is being generated can anyone out there help please!!!!

1 reply

by maxwell edison

Memory parity errors usually happen when the RAM is bad or mismatched, or is the incorrect type for that particular motherboard.

To test this possibility, replace the RAM with sticks that you know to be good. If it works with the new RAM, then you have to figure out if the old RAM is bad, mismatched or is the wrong type. I've found that RAM works best when the sticks are identical in every way - from the same lot.

My guess is that the modem may not really be the culprit, but the RAM becomes unstable only when accessing the modem is accessed.

Maxwell

This discussion is closed to new replies.