General discussion

Locked

modem config problem

By victorjulietpapa ·
I have an internal PCI modem mased on the Motorola SM65PCI chip and manufactured by manufactured by 'D-link'. It works fine with Win98 & Win2K but I have problems configuring it for RedHat Linux 7.3. I need some help on how to configure it. It is detected by Linux as a communications controller. As it is a PCI device (Location : PCI bus 0; Device 9; function 0) i have included the output of 'lspci' utility. I hope it is of some help.

Output of 'lspci -v' :

00:09.0 Communication controller: Analog Devices SM56 PCI modem
Subsystem: Analog Devices SM56 PCI modem
Flags: bus master, medium devsel, latency 64, IRQ 12
Memory at e6800000 (32-bit, prefetchable)
Capabilities: [dc] Power Management version 2


Output of 'lspci -vv' :

00:09.0 Communication controller: Analog Devices SM56 PCI modem
Subsystem: Analog Devices SM56 PCI modem
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (250ns min, 63750ns max)
Interrupt: pin A routed to IRQ 12
Region 0: Memory at e6800000 (32-bit, prefetchable)
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI- D1- D2+ AuxCurrent=0mA PME(D0+,D1-,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-

My computer is a Celeron 266MHz with 64MB RAM on a J7XB Motherboard. I use KDE as GUI. The primary OS on my computer is Win2K.


cheerio
veejay

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

modem config problem

by bg4 In reply to modem config problem

It may be a winmodem so may not be supported under linux. Have a look at linmodems.org and see if it is mentioned there.

Hope this helps.

Back to Linux Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums