General discussion

Locked

Modem connecting through command prompt

By software architect ·
I have an app that uses uses com1 to directly go to a modem, bypassing any windows drivers. I am using a US Robotics 56K fax modem ( called v anything in the industry ) I can use the atdt phone # >com1 in hyperterminal and successfully connect. But if I go to a command line all i get is lights flashing on modem and no dial tone. Any help would be appreciated.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Modem connecting through command prompt

by cportman In reply to Modem connecting through ...

Perhaps an ATZ before hand might help - not sure though. Those pesky at commands!

cp

Collapse -

Modem connecting through command prompt

by software architect In reply to Modem connecting through ...

Tried no luck

Collapse -

Modem connecting through command prompt

by software architect In reply to Modem connecting through ...

This question was closed by the author

Back to Windows Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums