Question

Locked

Monitor has power but no display and light blinks!!!

By Inayatullahsoomro ·
Ny CRT monitor ligt is green and blinking but no display, a sound of kit kit... is with the light blinking.... plz help me in this problem...

This conversation is currently closed to new comments.

4 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

Unplug the monitor from the computer and then reconnect it

by OH Smeg In reply to Monitor has power but no ...

If it still doesn't work the Video Card has come loose and you'll need to open the case and refit the Video Card.

Col

Collapse -

the video resolution setting may be out of range

by markp24 In reply to Monitor has power but no ...

HI

the video resolution setting may be out of range

Try booting in safe mode see if that works

Collapse -

Replace Power Cord

by jpmyers15 In reply to Monitor has power but no ...

If the above suggestions do not help, try replacing the power cord if you have one. Definitely check out that video card to make sure it's secure in its slot, like the other person suggested.

Collapse -

Video card probably

As above comments suggested, the blinking light tells you there isn't any video input. Check video cable connections and make sure video card is seated in it's slot. If that's all right, it's probably a bad video card. Of course I'm assuming that the computer is actually running OK. You should have power light on and hard drive light should flicker when you first turned it on, otherwise it could be a dead computer.

Back to Hardware Forum
4 total posts (Page 1 of 1)  

Related Discussions

Related Forums