Hardware

General discussion

Gravatar
0 Votes
Locked

Moouse not working

By kkthree ·
I have 2 button mouse(memorex)it is working fine.Recently I brought a new 3 Button(center wheel)GE mouse.This new GE mouse is not working though I loaded its driver, I want to delete previous mouse driver.Where can I found the old mouse driver in my system?Is it necessery to delete the old driver? Windows 98 and using PS/2 port.

This conversation is currently closed to new comments.

Thread display: Collapse - | Expand +

All Comments

gravatar
Collapse -

by Oz_Media In reply to Moouse not working

You can remove the old mouse from the ADD/Remove hardware icon in the Control Panel.

gravatar
Collapse -

by kkthree In reply to

Add/Remove hardware icon is there in Control panel?
I think it is Add/Remove programs only or Add new hardware.

gravatar
Collapse -

by OTL In reply to Moouse not working

If you only have one mouse in the system under control panel you probably will not need to remove the old mouse.

You could remove the mouse (mice) in system, use keyboard tab key to menuver to close and reboot. Use new driver from the floppy to reload mouse driver on bootup.

gravatar
Collapse -

by BSchmidt In reply to Moouse not working

Oz was on the right track. Go to Control Panel and double click System, click on the Hardware tab and it will list all your installed hardware (modems, monitor, etc.) There should be an entry for your mouse, and if the one you're wanting to remove is listed there you should be able to remove it.

gravatar
Collapse -

by BSchmidt In reply to

I take that back, OTL is on the right track too.

gravatar
Collapse -

by w2ktechman In reply to Moouse not working

You could go into device manager and remove it. Then go to actions and scan for changes, load the driver.

Back to Hardware Forum

Start or search

Related Discussions

Related Forums