Question Locked

Move XP boot partition to another drive but cannot log on

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have cloned an XP bootable partition from one drive (drive 0) to another drive (drive 2) on the same machine and then removed the original drive. I set up the BIOS to boot from drive 2.

XP starts OK but I cannot log on to the machine. When I try to log on as any user (administrator included) it loggs me off and sends me back to the logon prompt.

Can anyone tell me what I have done wrong?

10 replies

by maniacman

When XP detects a hardware change, especially on retail copies, it will assume that that the copy has been pirated and installed on another PC, thus requiring activation again. I was going to say to check your boot.ini file, but since you cloned the drive, the boot.ini file should be pointing at the proper location of you system partition. Try running an inplace repair on the new drive and see if the problem gets corrected, as it may well be that you're missing something from the new image or something is corrupt. Also, does your imaging software generate a new SID, or are you still using the old SID?

by thumbsup2

Please correct me if I'm wrong, but the orignal post said he left the new drive sitting in disk(2) and changed the BIOS to boot from this drive first.

Doesn't this mess with WinXP where it is expecting to boot from disk(0)? I'm presuming these were SATA drives and I'm not real cognisant of the order in which these things must be plugged in, if there's any requirement at all when speaking of WinXP. So, I'm asking on behalf of the poster (and myself). I've always just plugged them in as disk(0), never really thinking there was another way to do it.

Is there?

by zom

The drives are IDE. I dont think XP requires disk(0). XP boots OK using disk(2). I just cant log on any more.

by zom

Im not sure the activation would be a problem. I am only changing one piece of hardware at a time. But maybe.

I will try the inplace repair and see if that helps. I don't understand the problem that would require an inplace repair, but a solution will outrank wisdom here.

I would assume the clone would retain the old SID. Using Ghost.

by rob miners

Did it ask about activation?
If it didn't, before you try the inplace repair try this.

Boot from your CD, choose the repair option during setup, and run the Recovery Console. When you are logged on, you can run the FIXMBR command to fix the MBR.

Also is the drive on IDE0 and set to Master or Cable Select?

by zom

XP boots OK so the disk select and MBR must be OK. What I am trying to understand is why it doesnt let me log on when the exact same image does let me log on when I boot from the source disk.

I get no message about activation.

by rob miners

did you follow the instructions. Ghost dosn't always get it right. It wouldnt hurt to run chkdsk /r as well.

by zom

Thanks. Its for W2K and SBS but it sounds about right. I will look deeper on that path.

Bewdy cobber.

This discussion is closed to new replies.