Question Locked

My computer won't read the slave hard drive, it's not showing in BIOS

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I reinstall windows on the master hard drive, for some reason my slave hard drive cannot be read by windows it doen't even show on the BIOS. I have all my work on that drive please if there's a way for my computer to read the slave let me know I'm going crazy over here. The drive won't even warm up when I turn the computer on, like if it was empty inside. I have tried changing the cable a thousand times, even use a different tower and nothing. please, please help me... Foxy-D

5 replies

by captbilly1eye

Verify the power supply and the connection from it to the drive are valid and secure.
Make sure the jumper on the back of the drive is set to Slave.
Connect Master and Slave drives using the same ribbon cable (assuming you are using IDE).

by oh smeg

If it's a SATA Drive you most likely need to install the SATA Drivers. If that is the case you shouldn't see the Drive in BIOS or anywhere else until the OS is loaded and working properly with all the necessary drivers installed.

If it is an IDE Drive sometimes called PATA and you are unable to see it in BIOS the Hardware isn't properly setup.

Col

by aleczee

make it separated. i mean try to make it two IDE or SATA cable and seperate power too. you need to enter the bios of your computer and make some tweaking. you need to make it automatic or manual setting of your drive. the BIOS will need to detect first. so the windows can read it. if you dont know how to enter a bios check out your computer manual or motherboard document... that's all bye and god bless

by captbilly1eye

Were you able to resolve your issue?
If so, what was the ultimate resolution?

This discussion is closed to new replies.