General discussion

  • Creator
    Topic
  • #2305586

    nat and vpn using w2k3 PPPOE

    Locked

    by blue screen ·

    how do i setup nat and vpn using PPPOE builtin to the w2k3?
    when i ran the nat and vpn wizard and come to the part where it says choose the protocol that connects this computer to the internet i only see the NIC cards and not the PPPOE protocol, any ideas? or how do i setup nat and vpn and still use the PPPOE to connect to the internet?

All Comments

  • Author
    Replies
    • #3357150

      nat and vpn using w2k3 PPPOE

      by d.walker5 ·

      In reply to nat and vpn using w2k3 PPPOE

      If I understand your problem, you cannot connect to the Internet by using a shared DSL connection That uses PPP over Ethernet (PPPoP)?

      When connecting to the Internet through a shared DSL network connection, and the DSL connection uses PPPoE, you may not be able to connect to the Internet. This occurs if the PPPoE connection is configured for DSL instead of for a local area network (LAN).
      To corrrect behavior, configure the PPPoE connection for use on a LAN:
      On the computer that hasthe DSL connection, click Start, | Settings | Control Panel.
      Double-click Network and Dial-up Connections.
      Three local-area connections are listed: one for the LAN, one for the DSL network interface card (NIC), and one for the PPPoE connection.Right-click the PPPoE connection, click Properties, and then click the Sharing tab.
      Click Enable Internet Connection Sharing for this connection, click For Local Network, and then click Local Area Connection.
      Click OK.
      Right-click the LAN connection, click Properties, click Internet Protocol, and then click Properties.
      Verify the IP address is 192.168.0.1, and then click Cancel. Verify that the computer can gain access to the Internet.Restart the client computers, and verify that they also can gain access to the Internet. Hope this provides the answer.

    • #3190247

      Reply To: nat and vpn using w2k3 PPPOE

      by blue screen ·

      In reply to nat and vpn using w2k3 PPPOE

      This question was closed by the author

Viewing 1 reply thread