Question Locked

Need to press F1 and update to run from C drive on every restart

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On every restart I have to go to Bios and set my start up drive as c: and then save and run the syatem, else it will consider A: as my default drive and it wont go to windows. PLease help me on this.

10 replies

by robo_dev

Question: what is today's date?

If you answer January 1, 1980, then it's time for a new bios battery.

by manyabs

I have replaced the battery and checked still I see the same issue. This is happning from the day I brought my system...It worked for few days but then back to square one......

by manyabs

I have replaced the battery and checked still I see the same issue. This is happning from the day I brought my system...It worked for few days but then back to square one......

by manyabs

This is an assembled computer n that guy is no more there.....thats the reason I am suffering

by oh smeg

Some M'Boards have a Jumper on them to Clear the BIOS and the makers set these to Clear to save the Battery till the system gets assembled.

What you need to do is grab the M'Board book and look for the BIOS Clear Jumper and reset this to the On Position. That should cure your problem.

Col

by boxfiddler Hot topic

Seconded: means that Dumphrey agrees with robo_dev.
NT: means No Text anywhere else but the title so there is no sense clicking on the message title to read the message.

This discussion is closed to new replies.