General discussion

Locked

NetWare 5.1/TCP/IP Load sharing

By GolfKingUK ·
I just installed a Netware 5.1 server, it has 2 token ring cards and 2 ethernet cards.

I'd like for the 2 cards on each network to load share network traffic(IP). Does anyone know how to set this up?

Basically 1 card of each network type will pass IPX and both cards IP. Do I assign different IP addresses? I tried to do it suring setup, however, Netware stated do it after the install. When I give them 2 different IP addresses, only one works.

Thank in advance!

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

NetWare 5.1/TCP/IP Load sharing

by sleeper In reply to NetWare 5.1/TCP/IP Load s ...

check novell tid's 10015366, 10011336, 10024000

Collapse -

NetWare 5.1/TCP/IP Load sharing

by GolfKingUK In reply to NetWare 5.1/TCP/IP Load s ...

The question was auto-closed by TechRepublic

Collapse -

NetWare 5.1/TCP/IP Load sharing

by sleeper In reply to NetWare 5.1/TCP/IP Load s ...

check novell tid's 10015366, 10011336, 10024000

Collapse -

NetWare 5.1/TCP/IP Load sharing

by GolfKingUK In reply to NetWare 5.1/TCP/IP Load s ...

The question was auto-closed by TechRepublic

Collapse -

NetWare 5.1/TCP/IP Load sharing

by GolfKingUK In reply to NetWare 5.1/TCP/IP Load s ...

This question was auto closed due to inactivity

Back to Networks Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums