Discussion Locked

Network path not found error msg

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

guys,

i am suddenly getting the error msg above when i try to browse to that specific server in network neighborhood. what can be wrong? the server is a nt 4.0 server in a nt domain environment.

5 replies

by joseph moore

Perhaps the server in the domain you are trying to connect to is not on or not connected to the network. That would give you the network path error.
Also, if the server has a different IP address, but the WINS database in your network does not havethis new IP in it, then you would get the error. You would be trying to connect to the old IP address of the server, which won't work.
Basically, I would look at the WINS database for your network, and check out its registrations for this remote server.

hope this helps

by curlergirl

Other than the obvious things mentioned in the previous answer, this can be caused by the RPC service of the server being "hung". I've seen several incidences where this can happen - some were caused by antivirus real-time protection services hanging on start. You can test this by trying to connect to the server through Server Manager from another server or workstation. If you get a message that the RPC server is too busy to respond, then it's a service has hung and is also hanging the RPC service. You then have to try to determine what service is hanging and why and fix that. Hope this helps!

This discussion is closed to new replies.