General discussion

Locked

Network Routing

By mkartes ·
I am trying to setup a 2600 series router that is only using two FE ports. I am trying to route from one network to another. The network is 10.10.155.0(f0/0) and the other is 21.21.21.0(f1/0). The 21.0 is going to a firewall that is using VPN tunnel and the 155.0 network is going to a router on a similar subnet. I am not using the DSU/CSU card on this router only the Ethernet and an ethernet module. How do I get traffic to route over the 21.0 network?

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

locally attached network routing

by SYNner In reply to Network Routing

Your networks are attached to the same router. Just set the default gateway on the workstations and you should be able to get the two networks to talk to each other.

Back to Networks Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums