Discussion Locked

networking xp

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

networking xp
I have a new computer running XP with a cable modem connected via usb. Want to get data off old ME computer connected via nick cards. Ran the wizard, but I can't see the ME machine. Icon on XP machine shows open LAN connection. I thought networking was easier with XP. (I successfully networked a win 2000 machine to the ME in the past)

11 replies

by carol

.. Okay trying to understand your current setup. You have a USB cable modem. And you've connected a cat5 cable from between your XP and your ME machine. WAs this a Crossover cable? You can't use a straight-through cable unless you have both of these machines hooked into a hub.

Networking is easier in XP.
-Make sure to assign IP addresses which are on the same subnet on both computer's Ethernet NIC card connections.
- Right-click on the XP's Ethernet connection, and make sure that the built-in firewall is not enabled.
-Leave the TCP/IP settings on your USB at the default settings.

-Good luck

by sgt_shultz

some ideas...
1)have link lights? no-check cables. yes, ping by network name AND ip address. observe results.
2)have link lights AND can ping? no?--use ipconfig (2K) or winipcfg (ME) to check tcpip settings on each pc (see below), ping is yes?--check workgroup name on each and make sure you have a shared resource set up on ME. try accessing the ME computer from the command prompt on the 2k pc: Start/Run \\computername\sharename
(maybe browsing doesn't work but you can still connect...)
3)you can't see the ME from the 2K...how about vice-versa?
some things you gotta have (generally speaking: same-segment ip addresses (e.g., 192.168.0.9 and 192.168.0.10), same subnet mask (255.255.255.0 on both), be in same workgroup (not domain on one and workgroup on the other either), a shared resource in place...hope this helps a little...

by chrisrlg

A few queries:-
Which XP home or Pro
Have both machines drives been set to share.

I have noticed that winXP (both) do not list machines but open devices (drives, printers etc) so if drives not shared you might not see machine (ME or XP)
ME I have at home and found that this did not show all computers on net and you had to know the name of the machine and set it to then see it.

by lawson4u

On the Win Xp computer .run the setup a home or small office network wizard.Since the other computer has Win ME you will need to create a network setup floppy from the XP Putter and run it on the Me Putter. If You dont have a hub..Make sure to use acrossover cable and always look at your Nics to see if the lights are on.

This discussion is closed to new replies.