Question Locked

New Athlon 64 X2 system, no power. What should i do next?

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When I turn on the power supply (from the back) the mobo LED lights up green indicating it's receiving power on the board. But when i push the power button (on the case) the PSU makes a "ffft" (really short and not very loud) sound, and nothing turns on like fans, or lights or drives spinning up (except the green LED which was on before) Every time i hit the power button after that no sound, and no change.

After turning the PSU power off for a second (until the green LED turns off) and turning it back on it does the same thing again. I'm suspicious that there is a short somewhere. But I'm looking for input before i try anything else. This is all i have done. Troubleshooting steps?

I have another supply (350W Antec) to try. So I'm looking for a plan of attack.

Hardware:
NZXT 400W power supply (came with case)
ASUS M2N-E 570 mobo
Athlon 64 X2 4200+
Gemini II heatsink
2 GB RAM
2 80G drives in raid striping
4 120mm fans
2 DVD drives
Sapphire HD 2600 XT PCI-E video card

2 replies

by mjd420nova

Either something is shorting the power supply or the P/S unit has a short inside and that's what is causing the noise and failure. Being that the LED lights, the 5 volt supply is working but the 12 volts is sensing a short and protecting itself. Disconnect the drives (hard drive, CD/DVD) and try again. Then try the connector to the video card if an external connector is used, or unseat the card itself and try again. Last of all, disconnect the MOBO and try it that way. This procedure should reveal the fault causing device or if it's the P/S itself shorting out internally.

This discussion is closed to new replies.